Dell Networking Z9500, Справочник по командам

Страница: 1008 / 1905

Version 9.3.0.0 Added support for logging of ACLs on the S4810, S4820T,
and Z9000 platforms.
Usage
Information When the configured maximum threshold is exceeded, generation of logs is
stopped. When the interval at which ACL logs are configured to be recorded
expires, the subsequent, fresh interval timer is started and the packet count for that
new interval commences from zero. If ACL logging was stopped previously
because the configured threshold is exceeded, it is re-enabled for this new interval.
If ACL logging is stopped because the configured threshold is exceeded, it is re-
enabled after the logging interval period elapses. ACL logging is supported for
standard and extended IPv4 ACLs, IPv6 ACLs, and MAC ACLs. You can configure
ACL logging only on ACLs that are applied to ingress interfaces; you cannot enable
logging for ACLs that are associated with egress interfaces.
You can activate flow-based monitoring for a monitoring session by entering the
flow-based enable
command in the Monitor Session mode. When you enable
this capability, traffic with particular flows that are traversing through the ingress
and egress interfaces are examined and, appropriate ACLs can be applied in both
the ingress and egress direction. Flow-based monitoring conserves bandwidth by
monitoring only specified traffic instead all traffic on the interface. This feature is
particularly useful when looking for malicious traffic. It is available for Layer 2 and
Layer 3 ingress and egress traffic. You may specify traffic using standard or
extended access-lists. This mechanism copies all incoming or outgoing packets on
one port and forwards (mirrors) them to another port. The source port is the
monitored port (MD) and the destination port is the monitoring port (MG).
Related
Commands
permit (for Standard IPv6 ACLs) – configures a filter to forward IPv6 packets.
seq (for IPv6 ACLs)
Assign a sequence number to a deny or permit the filter in an IPv6 access list while creating the filter.
Syntax
seq sequence-number {deny | permit} { ipv6-protocol-number |
icmp | ip | tcp | udp} { source address mask | any | host ipv6-
address } { destination address | any | host ipv6-address }
[ operator port [ port ]] [count [byte]] [log [interval minutes ]
[threshold-in-msgs [ count ]] [monitor]
To delete a filter, use the
no seq sequence-number
command.
Parameters
log (OPTIONAL) Enter the keyword
log
to enable the triggering
of ACL log messages.
threshold-in
msgs
count
(OPTIONAL) Enter the
threshold-in-msgs
keyword
followed by a value to indicate the maximum number of ACL
logs that can be generated, exceeding which the generation
1008
IPv6 Access Control Lists (IPv6 ACLs)