Dell Networking Z9500, Справочник по командам

Страница: 1149 / 1905

interface
interface
(OPTIONAL) Enter the keyword
interface
then the
interface type, slot and port information:
• For a Port Channel interface, enter the keywords
port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
interface
interface-type
(OPTIONAL) Instead of entering the keyword
interface
then the interface type, slot and port information, as above,
you can enter the interface type, then just a slot number.
vlan vlan-id (OPTIONAL) Enter the keyword
vlan
then the VLAN ID to
display the MAC address assigned to the VLAN. The range is 1
to 4094.
count (OPTIONAL) Enter the keyword
count
, then optionally, by an
interface or VLAN ID, to display total or interface-specific
static addresses, dynamic addresses, and MAC addresses in
use.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.12.0 Updated the output.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage
Information The following describes the
show mac-address-table
command shown in the
following example.
Layer 2
1149