Dell Networking Z9500, Справочник по командам

Страница: 438 / 1905

Version Description
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
In the best path selection process, the path with the highest weight value is
preferred.
NOTE: In the best-path selection process, the path with the highest weight
value is preferred.
If you configure the
set weight
command in a route map applied to this
neighbor, the weight set in that command overrides the weight set in the
neighbor weight
command.
Related
Commands set weight — assigns a weight to all paths meeting the route map criteria.
network
Specify the networks for the BGP process and enter them in the BGP routing table.
Z9500
Syntax
network ip-address mask [route-map map-name ]
To remove a network, use the
no network ip-address mask [route-map
map-name ]
command.
Parameters
ip-address Enter an IP address in dotted decimal format of the network.
mask
Enter the mask of the IP address in the slash prefix length
format (for example, /24).
The mask appears in command outputs in dotted decimal
format (A.B.C.D).
route-map
map-name
(OPTIONAL) Enter the keyword
route-map
then the name
of an established route map.
Only the following ROUTE-MAP mode commands are
supported:
• match ip address
• set community
• set local-preference
• set metric
438
Border Gateway Protocol