Dell Networking Z9500, Справочник по командам

Страница: 544 / 1905

To return to the default values, use the
no neighbor { ipv6-address | peer-
group-name } maximum-prefix maximum [ threshold ] [warning-only]
command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name Enter the name of the peer group.
maximum Enter a number as the maximum number of prefixes allowed
for this BGP router. The range is 1 to 4294967295.
threshold (OPTIONAL) Enter a number to be used as a percentage of
the maximum value. When the number of prefixes reaches
this percentage of the maximum value, the software sends a
message. The range is 1 to 100 percent. The default is
75 .
warning-only (OPTIONAL) Enter the keywords
warning-only
to set the
router to send a log message when the maximum value is
reached. If you do not set this parameter, the router stops
peering when the maximum number of prefixes is reached.
Defaults
threshold
= 75
Command
Modes ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Usage
Information If you configure the
neighbor maximum-prefix
command and the neighbor
receives more prefixes than allowed by the
neighbor maximum-prefix
command configuration, the neighbor goes down and the
show ip bgp
summary
command displays ( prfxd ) in the State/PfxRcd column for that neighbor.
The neighbor remains down until you enter the
clear ip bgp
command for the
neighbor or the peer group to which the neighbor belongs or you enter the
neighbor shutdown
and
neighbor no shutdown
commands.
Related
Commands show ip bgp summary – displays the current BGP configuration.
544
Border Gateway Protocol