Dell Networking Z9500, Справочник по командам

Страница: 1297 / 1905

Parameters
process-id Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Added output for LSA throttling timers.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support of Multi-Process OSPF.
7.8.1.0 Added the
process-id
option, in support of Multi-Process
OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
Usage
Information If you delete all the network area commands for Area 0, the
show ip ospf
command output does not list Area 0.
The following describes the
show ip ospf
command shown in the following
example.
Line Beginning
with Description
“Routing
Process...” Displays the OSPF process ID and the IP address associated
with the process ID.
“Supports only...” Displays the number of Type of Service (TOS) rouse
supported.
“SPF schedule...” Displays the delay and hold time configured for this process
ID.
“Convergence
Level”
Open Shortest Path First (OSPFv2 and OSPFv3)
1297