Omron SYSDRIVE 3G3RV, User Manual

Page: 97 / 446

Modes
3-
5
Modes
This
section describes the Inverter's modes and switching between modes.
K K K K
Inverter Modes
The
Inverter's parameters and monitoring functions are organized in groups called modes that make it easier to
read
and set parameters.The Inverter is equipped with 5 modes.
The
5 modes and their primary functions are shown in the Table 3.2.
* Always
perform autotuning with the motor before operating using vector control. Autotuning Mode will not be displayed during operation or when an
error
has occurred.
Table 3.2 Modes
Mode Primary function(s)
Drive
Mode
The
Inverter can be run in this mode.
Use
this mode when monitoring values such as frequency references or output cur-
rent,
displaying fault information, or displaying the fault history.
Quick
Programming Mode
Use
this mode to reference and set the minimum parameters to operate the Inverter
(e.g.,
the operating environment of the Inverter and Digital Operator).
Advanced
Programming Mode
Use
this mode to reference and set all parameters.
Verify
Mode
Use
this mode to read/set parameters that have been changed from their factory-set
values.
Autotuning
Mode*
Use
this mode when running a motor with unknown motor constants in the vector
control
mode. The motor constants are calculated and set automatically.
This
mode can also be used to measure only the motor line-to-line resistance.