Omron SYSDRIVE 3G3RV, User Manual

Page: 84 / 446

2
-48
n
Preventing C and D Option Card Connectors from Rising
After
installing an Option Card into slot C or D, insert an Option Clip to prevent the side with the connector
from
rising. The Option Clip can be easily removed by holding onto the protruding portion of the Clip and
pulling
it out.
* An Option Card in Mounting Location D is supported by Asian Models only. Other models do not have the CN3 connector shown in Fig 2.34.
Fig 2.34 Mounting Option Cards
K K K K
PG Speed Control Card Terminals and Specifications
The
terminal specifications for the PG Speed Control Cards are given in the following tables.
n
3G3FV-PPGA2
The
terminal specifications for the 3G3FV-PPGA2 are given in the following table.
Table 2.25 3G3FV-PPGA2 Terminal Specifications
Terminal No. Contents Specifications
TA1
1
Power
supply for pulse generator
12
VDC (±5%), 200 mA max.
2 0
VDC (GND for power supply)
3
+12
V/open collector switching ter-
minal
Terminal
for switching between12 V voltage input
and
open collector input. For open collector input,
short
across 3 and 4.
4
5
Pulse
input terminal
H:
+4 to 12 V; L: +1 V max. (Maximum response fre-
quency:
30 kHz)
6 Pulse
input common
7
Pulse
motor output terminal
12
VDC (±10%), 20 mA max.
8 Pulse
monitor output common
TA2 (E) Shield
connection terminal
-
A Option Card mounting spacer hole
4CN
A Option Card connector
2CN
C Option Card connector
A Option Card mounting spacer
(Provided with A Option Card.)
Option Clip
(To prevent raising of
C and D Option Cards)
3CN
D Option Card connector*
A Option Card
A Option Card mounting spacer
D Option Card mounting spacer
C Option Card mounting spacer
D Option Card
C Option Card