Omron SYSDRIVE 3G3RV, User Manual, Page: 355 / 446

Digital Operator Functions
6-
139
n
Writing Parameter Set Values Stored in the Digital Operator to the Inverter (COPY)
To
write parameter set values stored in the Digital Operator to the Inverter, make the settings using the follow-
ing
method.
During
the copy operation, errors may occur. If an error is displayed, set the parameters again. Error displays
and
their meanings are shown below. (Refer to Chapter 7 Errors when Using Digital Operator Copy Func-
tion.)
Table 6.7 COPY Function Procedure
Step
No.
Digital Operator Display Explanation
1
Press
the MENU Key, and select advanced pro-
gramming
mode.
2
Press
the ENTER Key, and select the parame-
ters
monitor display.
3
Display
o3-01 (Copy Function Selection) using
the
Increment Key and Decrement Key.
4
Press
the ENTER Key, and select the parame-
ters
setting display.
5
Change
the set value to 2 using the Increment
Key.
6
Set
the changed data using the ENTER Key.
The
COPY function will start.
7
If
the COPY function ends normally, End is dis-
played
on the Digital Operator. Parameter o3-
01
is automatically reset to 0, and then the dis-
play
returns to o3-01.
Error Display Meaning
Inverter
product code and Inverter software number are different.
Inverter
capacity with which you are trying to copy, and the Inverter capacity stored in the Digital
Operator
are different.
The
Inverter control method in which you are trying to copy, and the Inverter control method stored
in
the Digital Operator are different.
Comparison
between the parameter written to the Inverter and the parameter in the Digital Operator
shows
they are different.
After
copying has ended, comparison between the sum value of the Inverter parameter area and the
sum
value of the Digital Operator parameter area shows they are different.
DRIVE QUICK VERIFY ADV AUTO
TUNING
DRIVE QUICK VERIFY ADV AUTO
TUNING
DRIVE QUICK VERIFY ADV AUTO
TUNING
DRIVE QUICK VERIFY ADV AUTO
TUNING
DRIVE QUICK VERIFY ADV AUTO
TUNING
DRIVE QUICK VERIFY ADV AUTO
TUNING