Omron SYSDRIVE 3G3RV, User Manual

Page: 100 / 446

3
-8
K K K K
Quick Programming Mode
In
Quick Programming Mode, the parameters required for Inverter trial operation can be monitored and set.
Parameters
can be changed from the setting displays. Use the Increment, Decrement, and Digit Selection/
RESET
Keys to change the frequency. The parameter will be written and the monitor display will be returned
to
when the ENTER Key is pressed after changing the setting.
Refer
to Chapter 5 Parameters for details on the parameters displayed in Quick Programming Mode.
n
Example Operations
Key
operations in Quick Programming Mode are shown in the following figure.
Fig 3.5 Operations in Quick Programming Mode (Example for the 3G3IV-PJVOP161)
Quick Programming Mode
DRIVE QUICK VERIFY ADV
Mode Selection Display
MENU
Monitor Display Setting Display
Control method selection
Reference selection
Operation method selection
Stopping method selection
Motor protection selection
Deceleration stall selection
AO CH2 output gain
AO CH1 output gain
C1-01: Acceleration time 1
C1-02: Deceleration time 1
C6-01: CT/VT selection
C6-02: Carrier frequency
selection d1-01: Frequency reference 1
d1-02: Frequency reference 2
d1-03: Frequency reference 3
d1-04: Frequency reference 4
d1-17: Jog frequency reference
E1-01: Input voltage setting
E1-03: V/f pattern selection
E1-04: Max. output frequency
E1-05: Max. voltage
E1-06: Base frequency
E1-09: Min. output frequency
E1-13: Base voltage (VBASE)
E2-01: Motor rated current
DRIVE QUICK VERIFY ADV
ESC
ESC
ESC
ESC
ESC
ESC
ESC
ESC
ESC
ESC
ESC
ESC
ESC
ESC
ESC
AUTO
TUNING
AUTO
TUNING