Mitsubishi A1SD75P1-S3, User Manual

Page: 536 / 622

14 - 25
MELSEC-A
14 TROUBLESHOOTING
Relevant buffer memory address
Axis 1 Axis 2 Axis 3
Setting range
(Setting given in sequence program)
Remedy
30 180 330
0: Positive logic
1: Negative logic
31 181 331
0: One-word type
1: Two-word type
Change the setting to within the setting range and turn
OFF then ON the PLC READY signal (Y1D).
15 165 315 0 to 255
Change the setting so that the movement per pulse
converted to the pulse count becomes fewer than 256
pulses. (Refer to section 12.3.1)
36
37 186
187 336
337
(One-word type)
1 to 65535
(Two-word type)
1 to 8388608
38
39 188
189 338
339
(One-word type)
1 to 65535
(Two-word type)
1 to 8388608
40
41 190
191 340
341
(One-word type)
1 to 65535
(Two-word type)
1 to 8388608
42
43 192
193 342
343
(One-word type)
1 to 65535
(Two-word type)
1 to 8388608
44
45 194
195 344
345
(One-word type)
1 to 65535
(Two-word type)
1 to 8388608
46
47 196
197 346
347
(One-word type)
1 to 65535
(Two-word type)
1 to 8388608
Change the setting to within the setting range and turn
OFF then ON the PLC READY signal (Y1D).
48
49 198
199 348
349
(In standard mode)
1 to 1000000 [pulse/s]
1 to 600000000 [mm/min, etc.]
(In stepping motor mode)
1 to 62500 [pulse/s]
1 to 37500000 [mm/min, etc.]
•
Change the setting to within the setting range and turn
OFF then ON the PLC READY signal (Y1D).
•
Change the setting to within the speed limit value.
50 200 350 0, 1, 2 ,3
Change the setting to within the setting range and turn
OFF then ON the PLC READY signal (Y1D).
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com