Mitsubishi A1SD75P1-S3, User Manual

Page: 533 / 622

14 - 22
MELSEC-A
14 TROUBLESHOOTING
Division of
error
Error
code
Error name Description Action at occurrence of error
922
Software stroke
limit lower limit
•
The “software stroke limit lower limit value”
setting in detail parameter 1 is out of the
setting range with “degree” unit.
•
The software stroke limit upper limit value is
smaller than the software stroke limit lower
limit value with a unit other than “degree.”
923
Software stroke
limit selection
The setting range of “software stroke limit
selection” in detail parameter 1 is out of the
setting range.
924
Software stroke
limit valid/invalid
setting The setting range of the “software stroke limit
valid/invalid setting” in detail parameter 1 is out
of the setting range.
925
Illegal torque limit
setting value
The setting range of the “torque limit setting
value” in detail parameter 1 is out of the setting
range.
926
Command in-
position range
The setting range of the “command in-position
range” in detail parameter 1 is out of the setting
range.
927
M code ON
timing error
The setting range of the “M code ON signal
output timing” in detail parameter 1 is out of the
setting range.
928
Speed
changeover
mode error The setting range of the “speed changeover
mode” in detail parameter 1 is out of the setting
range.
929
Interpolation
speed
designation
method
The setting range of the “interpolation speed
designation method” in detail parameter 1 is
out of the setting range.
930
Current value
update request
error The setting range of the “current feed value
during speed control” in detail parameter 1 is
out of the setting range.
Parameter
931
Manual pulse
generator
selection error
The “manual pulse generator selection” setting
in detail parameter 1 is out of the setting range.
The AD75 READY signal (X0) is not turned
OFF.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com