Mitsubishi A1SD75P1-S3, User Manual

Page: 532 / 622

14 - 21
MELSEC-A
14 TROUBLESHOOTING
Relevant buffer memory address
Axis 1 Axis 2 Axis 3
Setting range
(Setting given in sequence program)
Remedy
0 150 300 0, 1, 2, 3
1 151 301 1 to 65535
2 152 302 1 to 65535
3 153 303 1, 10, 100, 1000
4 154 304 0, 1, 2, 3
5 155 305 0, 1
6
7 156
157 306
307
(In standard mode)
1 to 1000000 [pulse/s]
1 to 600000000 [mm/min, etc.]
(In stepping motor mode)
1 to 62500 [pulse/s]
1 to 37500000 [mm/min, etc.]
8
9 158
159 308
309 (One-word type) 1 to 65535
(Two-word type) 1 to 8388608
10
11 160
161 310
311 (One-word type) 1 to 65535
(Two-word type) 1 to 8388608
12
13 162
163 312
313
(In standard mode)
1 to 1000000 [pulse/s]
1 to 600000000 [mm/min, etc.]
(In stepping motor mode)
1 to 62500 [pulse/s]
1 to 37500000 [mm/min, etc.]
Change the setting to within the setting range and turn
OFF then ON the PLC READY signal (Y1D).
16
17 166
167 316
317
(In standard mode)
•
[mm] [inch] [pulse]
-2147483648 to 2147483647
•
[degree] 0 to 35999999
(In stepping motor mode)
•
[mm] [inch] [pulse]
–134217728 to 134217727
•
[degree] 0 to 35
•
Change the setting to within the setting range.
•
In case of a unit other than “degree,” change the settings
so that the lower limit value is smaller than the upper limit
value.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com