Mitsubishi A1SD75P1-S3, User Manual

Page: 540 / 622

14 - 29
MELSEC-A
14 TROUBLESHOOTING
Relevant buffer memory address
Axis 1 Axis 2 Axis 3
Setting range
(Setting given in sequence program)
Remedy
74
75 224
225 374
375
(In standard mode)
1 to 1000000 [pulse/s]
1 to 600000000 [mm/min, etc.]
(In stepping motor mode)
1 to 62500 [pulse/s]
1 to 37500000 [mm/min, etc.]
76
77 226
227 376
377
(In standard mode)
1 to 1000000 [pulse/s]
1 to 600000000 [mm/min, etc.]
(In stepping motor mode)
1 to 62500 [pulse/s]
1 to 37500000 [mm/min, etc.]
78 228 378 0, 1
86 236 386 1 to 300
80
81 230
231 380
381
(In standard mode)
0 to 2147483647
(In stepping motor mode)
0 to 134217727
82 232 382 0, 1, 2 ,3
83 233 383 0, 1, 2 ,3
88 238 388 0, 1
Change the setting to within the setting range and turn
OFF then ON the PLC READY signal (Y1D).
•
Write the flash ROM again.
•
If the same error persists, replace the module.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com