GRAUPNER mz-24 PRO, Programming Manual

Page: 229 / 240

ESC ( E lectronic S peed C ontroller)
This display shows the data from a HoTT compatible
brushless controller connected to the receiver with in-
tegrated telemetry.
The display shows the current and maximum electri-
cal values of the drive, the current and maximum tem-
perature of the controller, and the current and maxi-
mum speed of the motor connected to the controller.
It has the following meaning:
Value Explanation
QUA Transmitter signal quality received by
the receiver expressed as percentage,
see page
101 .
Cur-VOLT-
Min left value: actual input voltage
Right value: lowest input voltage since
the device has been switched on
Cur-
TEMP-
Max Left value: current controller tempera-
ture
Right value: maximum controller tem-
perature since the device has been
switched on
Cur-RPM-
Max Left value: current motor speed
Right value: maximum motor speed
since the device has been switched on
Cur-AMP-
Max Left value: Momentary current
Right value: maximum current since
the device has been switched on
Microcopter display
This display shows the data of a HoTT-compatible mi-
crocopter and appears after the display of the electric
air, Vario and GPS module. It has the following mean-
ing (from top to bottom starting on the left):
Value Explanation
VOLT Actual voltage
Time Time turned on
mAh Used battery charge since the device
has been turned on
00 Position number of the satellite
kmh Speed above ground calculated by the
GPS system
ALT Current altitude relative to the starting
location
RIC Direction of movement
AMP Momentary current
m Distance from the starting location
calculated by the GPS system
000 Position in angular degrees relative to
the starting location calculated by the
GPS system
Messages from the microcopter sensor are displayed
in the bottom line in the above display.
229 Telemetry data display