GRAUPNER mz-24 PRO, Programming Manual

Page: 197 / 240

If in the sub-menu " CTL Set " a switch or a con-
trol has been assigned to the output "CH6",
for example the left proportional control lever
"SL2" …
... then all the provided flaps move in the po-
sition corresponding to the control position
("
CTL Set "), offset value and travel setting so
as ("
Flap MIX
") RATE and offset values of the
respective flaps positions.
Notice
Set therefore the clarity as far as possible
only in one of the involved sub-menus val-
ue.
• " ACT " = ON
As long as " ACT " is activated …
… only the standard or previously customized
offset values of the "aileron" option of the "
Flap
MIX " sub-menu are valid …
... so as the following described RATE setting of
the "AILERON" display page of the "
Flap set
"
sub-menu …
… on the standard flap servos 6 and 7 so as 9
and 10, or in case of a model with only one flap
servo only to the servo 6.
If in the sub-menu "
CTL Set " a switch or a con-
trol has been assigned to the output "CH6",
for example the left proportional control lever
"SL2" so as an offset value, e.g. …
… then all the provided flaps move to the con-
trol position ("
CTL Set "),
Offset and travel settings so as to the RATE val-
ues of the following described aileron displays
of the "
Flap set
" sub menu. And all the flaps
accordingly to the addiction of ("
CTL Set
")
control position, offset value and travel settings
so as ("
Flap MIX ") offset and the RATE values
of the following described aileron display of the
"
Flap set " sub-menu.
Notice
Set the clarity as far as possible only in one
of the involved sub-menus value.
In the displays described below, you
specify the effect of the control elements assigned
to channel 6 in the "
CTL Set " sub-menu, in the
form of a phase trim on the positions of the aile-
rons, flaps, and possibly the elevators.
• Ctrl/sw option (control/switch)
In the value field in the Ctrl/sw column, you as-
sign a control or control switch for a specific phase
to the mixer as described in the section
Control
and switch assignment , for example in the phase
"THERMAL":
197 Function menu | Airplane models - Flaps settings