GRAUPNER mz-24 PRO, Programming Manual

Page: 143 / 240

In the case of older transmitters of the " D " and " FM "
type, check the servo direction and control mode and
change them if necessary by switching the corre-
sponding cables. If necessary, turn off all the mixers
or set them to zero.
Notices
• If you forget to assign a control in the PUPIL
transmitter, the relevant servo(s) remain in
middle position after transferring control func-
tions to the PUPIL transmitter.
• Independent of the type of RF link of the
TEACH transmitter to the model, the PUPIL
transmitter should always be operated in nor-
mal PPM mode.
Teacher/Pupil function
Both transmitters are connected to each other using
an appropriate cable (see the overview on the next
page): Insert the plug identified as "
M " (master) in
the socket of the TEACH transmitter, and insert the
plug with "
S " (student) (depending on the available
cable) in the socket of the PUPIL transmitter.
Attention
BEFORE starting trainer mode for the operational
model, be sure to check whether all the functions
have been correctly transferred.
Notice
Do not insert an end of your trainer cable identi-
fied with "S" or "M" with a 3-pin jack plug into a
socket of the DSC system. It is not designed for
this purpose. The DSC socket can only be used for ca-
bles with a 2-pin jack plug.
Trainer cable
4179.1
for trainer mode between any two Graupner
transmitters with a DSC socket which can
be identified by a 2-pin jack plug on both
ends.
3290.7 Trainer cable to connect a TEACH transmit-
ter having a DSC socket (such as an
mc-
16 to an mz-24 HoTT Pro transmitter, or a
transmitter retrofitted with the optional DSC
module - order No.
3290.24 ) to a Graupner
PUPIL transmitter with a PUPIL socket for
the optoelectronic system - identifiable by
the "
S " on the side of the three-pin jack
plug.
3290.7 Trainer cable to connect a TEACH transmit-
ter having a DSC socket (such as an mc-
16 to an mz-24 HoTT Pro transmitter, or a
transmitter retrofitted with the optional DSC
module - order No.
3290.24 ) to a Graupner
PUPIL transmitter with a PUPIL socket for
the optoelectronic system - identifiable by
the "M" on the side of the three-pin jack
plug.
Additional information on the cables and modules
mentioned in this section for the TEACH and PUPIL
transmitters can be found in the relevant transmitter
instructions in the main
Graupner FS catalogue, and
on the Internet at www.graupner.de .
143 Function menu | general - Trainer