GRAUPNER mz-24 PRO, Programming Manual

Page: 226 / 240

In addition, make sure that the relevant receiver is
bound (as described above) in the line "BIND ON/
OFF" of the sub-menu "Tx SET" of the base menu
"
TX ctl
" and that the receiver is selected in the " RE-
CEIVER SELECT " line of the " Telemetry " menu (RX1
… RX2), and that the receiver is turned on. If another
receiver has been selected, only the data from this
receiver is displayed in the "Receiver" display.
In addition, sensors in the sub-menu "
SETTING &
DATA VIEW " of the "
Telemetry
" menu will only re-
spond under the above prerequisite corresponding to
the instructions for the respective sensor.
You can switch between the displays of the automat-
ically activated sensors by touching the
NEXT
button
at the top edge of the display...
Touch
... and switch to the next sensor by touching the but-
ton again.
Tip
Further information on the modules cited below can be
found in the Annex and on the Internet at
www.graupner.
de for the respective product.
RECEIVER
This display offers a graph of the data from the display
"
RX DATAVIEW " of the " Telemetry " menu "SETTINGS
& DATAVIEW".
It has the following meaning:
Value Explanation
R … dB Level in dBm expressed as the per-
centage of the transmitter signal arriv-
ing at the receiver
T … dB Level in dBm expressed as the per-
centage of the receiver signal arriving
at the transmitter
VOLT Current operating voltage of the receiv-
er power supply in Volts
Min V Lowest operating voltage of the receiv-
er power supply since the last startup
in Volts
TEMP The thermometer visualizes the current
operating temperature of the receiver
Q Quality expressed as a percentage of
the signal packages from the transmit-
ter arriving at the receiver
S Signal strength expressed in percent-
age of the signal from the transmitter
arriving at the receiver
L Shows the longest time in ms in which
the data packets are lost during a
transmission from the transmitter to
receiver
Tip
Detailed explanations of the terms in the "Value" column
can be found in the section "
RX DATA VIEW ".
GENERAL MODULE
226 Telemetry data display