GRAUPNER mz-24 PRO, Programming Manual

Page: 66 / 240

This sub-menu is not shown in model type "glider with-
out motor".
In the basic transmitter display, use your finger or the
provided stylus to touch the gear icon labeled "B":
Touch
The display switches to the "green" base menu. Touch
the menu item
"
THR.CUT ".
Touch
Throttle Cut
In this "Throttle Cut" option, you can turn off a speed
controller with a switch, or move a servo for the throt-
tle control in the pre-defined motor OFF position (or
to idle position).
This option can also be used as an emergency OFF
function as well. The motor OFF position, or also an
idle position, is designated in the value field of the
Throttle Cut
Switchable throttle cut or motor limiter
"SET" line and needs to be determined through ex-
perimentation.
The speed controller or the throttle servo only as-
sumes the set position if a freely selectable switch has
been activated ...
• By moving the selected switch to the ON posi-
tion the speed controller or the governor will be
reduced to the value which has been input in the
"SET" line, independently from the actual position
of the throttle/brake or throttle/pitch control stick.
... and in models with ICE engine also this passage
must be performed:
• If the set percentage in the "SET" line is
less than
the current servo position, that is, the current servo
position represented by the green arrow to the left
of the bar graphic is
above the switching threshold
represented by the red arrow in the bar graphic,
the speed controller reduces the motor speed, or
the throttle servo closes the carburetor as speci-
fied in the "SET" line once the servo position
falls
below the switching threshold of -66% when the
switch is in the ON position.
• If the control stick position, represented by the
green arrow on the left of the bar graphic, is actu-
ally
under the red arrow on the right of the graph-
ic, the speed controller or governor increases the
motor speed or the throttle servo opens the car-
buretor as specified in the "SET" line, after moving
the switch to the ON position as soon as the con-
trol stick moves
over +66% or under -66% of the
switch threshold if the motor OFF position is set in
the plus side.
• In this motor OFF position, the speed controller or
the governor are disabled until the selected switch
is not moved again.
The preset value of the field in the "SET" line of the
idle or "motor off" position is -100% of the throttle/
brake or throttle/pitch control stick travel:
Programming
To change the default for the "Motor OFF" posi-
tion, touch the value field in the "SET" line:
Touch
The color of the field switches from black to blue:
66 Base menu - Motor stop