GRAUPNER mz-24 PRO, Programming Manual

Page: 46 / 240

Notices
• The possibility to reverse the direction of the
servos connected to the output 6 (C6) in a
helicopter model and the output 1 (C1) in the
other types is only offered to match with the
different building cases. Otherwise the switch-
on warning will react not properly. For this rea-
son a change in the value field is only possible
after confirming the "SURE?" warning.
• Independent of trim controls and any mix
settings, the neutral position can be shifted
around ±125% within the maximum servo
travel of ±150%. The servo is always adjusted
directly independent of all other trim and mix
settings.
Note that if the neu-
tral position is ad-
justed strongly, ser-
vo travel on one side
may be restricted
since the total travel
is limited to ±150%
for electronic and
mechanical reasons.
Tap on the WIZ. button at the top left to go to the next
option ...
• "3Sv (2Nick)"
Symmetrical three-point axis as before, but rotat-
ed 90°; one roll servo on the side, and two nick
servos, front and rear.
• "4Sv (90)"
Four-point control of the swashplate by means of
two roll servos and two nick servos.
Directly after you make your swash plate selection,
the following display appears ...
"Propulsion type"
... where you specify whether your helicopter is driven
by an electric motor or ICE engine:
After you select the propulsion mode, the assistant
takes you to the first model-dependent settings in the
following display...
"REV/SUB" (Servo reverse/Servo sub trim)
Tip
In order to set control channels with numbers higher
than CH6, touch
NEXT [ change page ].
In this display you can set on the left column the di-
rections and on the right column the neutral positions
of each servo
phase specific by tapping on the related
button, for example in the second display page to find
the servo 8:
Touch
46 Base menu - Model selection