GRAUPNER mz-24 PRO, Programming Manual

Page: 51 / 240

Select the desired point L, 1 ... 5 or H in the
actually blue, then active, value field by tap-
ping on the
+
or
–
button which are locat-
ed on the right side of the display, for ex-
ample:
Touch the RES button to reset a changed
value in a blue (active) value field to the de-
fault value.
Notice
The associated controller does not
have any effect if an undefined point is
selected (in the basic version of the rel-
evant curve mixers, only the points "L" and
"H" are set).
Select the desired mixer in the actually blue,
then active, value field by tapping on the
+
or
–
button which are located on the right
side of the display, for example:
Touch the RES button to reset a changed
value in a blue (active) value field to the de-
fault value.
• "POINT" column
You have selected one or more mixers in the
lines of the "Mixer" column. In the "POINT"
column, specify the support point(s) to be
trimmed.
To select a point, touch the button in the
"POINT" column in the desired line with a
finger or the provided stylus, for example:
• "PHASE" column
If you want to, specify in the right "PHASE"
column the programmed phases in which
the governor should be active. In the value
field, in the example, "1 (normal)", the num-
ber refers to the phase number that can be
found in the sub-menu "
PHASE ".
To select another phase than default Phase1,
touch the button in the "Phase" column in
the desired line with a finger or the provided
stylus, for example:
You can change the current Phase number
in the blue (active) value field by touching
the
+ or – buttons at the right edge of the
display the desired number of times, for ex-
ample:
Touch the RES button to reset a changed
value in a blue (active) value field to the de-
fault value.
51 Base menu - Model selection