GRAUPNER mz-24 PRO, Programming Manual

Page: 141 / 240

The mz-24 HoTT Pro transmitter comes standard
with a DSC socket in the rear of the transmitter. This
can be used to connect flight simulators but also to
integrate the transmitter into a cable-linked trainer
system.
In the basic transmitter display, touch the gear icon
labeled "F":
Touch
The display switches to the blue function menu. Touch
the menu item "
Trainer ".
Touch
Trainer
Connection between two transmitters with a DSC cable
Notice
The above figure shows the initial status of this
sub-menu: The PUPIL control has not been re-
leased; neither has a switch been assigned.
TEACH transmitter settings
An mz-24 HoTT Pro TEACH transmitter can be con-
nected to any suitable PUPIL transmitter, including
transmitters with a classic 35/40 MHz range.
The model to be controlled by the PUPIL
must be pro-
grammed with all its functions including trimming and
any mixed functions in a model memory of the mz-24
HoTT Pro TEACH transmitter. The HoTT receiver of
the relevant model must also be bound to the TEACH
transmitter since it is responsible for controlling the
model even in PUPIL mode.
You can transfer up to 12
function inputs ,see " Defi-
nition of terms ",of a mz-24 HoTT TEACH transmitter,
to the PUPIL transmitter, either individually or in any
desired combination.
The standard with
TEACH. labeling value field or
button indicate the Function inputs 1 … 4, which are
normally in all the model types assigned to the control
sticks functions so as the standardly "free"
Function
inputs 5 … 12 in the " CTL Set " sub-menu.
Notice
It does not matter which specific controls are as-
signed to the control function inputs to be trans-
ferred to the PUPIL. They can only be assigned in
the " CTL Set " sub-menu when the trainer connection is
turned off.
Select by touching the control function inputs 1 to 12
to be transferred to the PUPIL, for example :
Observe the standard conventions in the model types
"motor airplane" and "glider" so as in the model type
"helicopter" when assigning control functions:
Channel Function
1 Motor/airbrake or pitch
2 Aileron or Roll
3 Elevator or Nick
4 Rudder or Yaw
TO be able to switch between teacher and pupil a
trainer-switch must be assigned in the "CTL" value
field right in the top of the display, as described in the
"
Control and switch assignment " section.
It is preferable to use an intermittent switch so that
you can withdraw the control from the trainer at any
time, such as S8:
141 Function menu | general - Trainer