Repairs/Adjustments
07/23/2020
GBC StreamWire
4-202
ADJ 1.18 Knife Blade Adjustment
This adjustment will ensure the Knife blade is aligned to the cutting
surface. If the alignment is poor, the Knife may fail to cut the wire.
Perform this adjustment every time the Knife blade is replaced. This
adjustment can also be done if there is poor or inconsistent cutting of the
wire.
Adjustment Procedure
1) Open the Element Feed Drawer and remove the Knife Cover.
2) Loosen the two screws securing the Knife Blade. Use a 7mm wrench
and 3 mm Allen key. Loosen the knife until the blade is able to move
freely, but do not completely remove the screws.
3) Close the Element Feed Drawer and cycle the knife. Watch and listen
to the knife as it cycles. When the Knife is in its down position, pull
the interlock cheat key or open a cover to stop the motion.
Service Menu
Function Tests
Knife Cycle
4) Open the Element Feed Drawer and verify that the Knife blade is fully
pressed against the cutting block. Using a flashlight, check to make
sure no light can be seen between the knife and anvil in the cutting
area. Light can be visible below this area by the mounting screws.
5) Re-tighten the screws securing the Knife Blade.
6) Close the Element Feed Drawer and home the eWire.
7) Run the Feed Element command several times using A size wire (or
the smallest wire you have available) to ensure that the wire is cut
cleanly each time.
Service Menu
Function Tests
Feed Element
Cutting
Area
Summary of Contents for StreamWire
