Repairs/Adjustments
07/23/2020
GBC StreamWire
4-34
6. Disconnect the Steering Module Assembly by removing the M4
Screws from the front of the frame (4) and the back of the frame (4).
Support the Steering Module with your free hand while removing
the last screws.
7. Carefully slide the Steering Module out of the Lower Bypass.
Installation Procedure
1. Slide the new Steering Module Assembly into the Lower Bypass,
aligning the M4 screw holes.
2. Tighten the M4 Screws on the front frame (4) and rear frame (3) to
secure the Steering Module.
3. Re-connect the cables to the Steering Module.
4. Re-connect the Ground Strap.
5. Do REP 1.1
6. Connect the Power Cord.
7. Power ON the eWire.
REP 2.22 Steering Motor Replacement, M16 and M17
PARTS LIST ON PL 5.3
Use the following procedures to remove and install the Steering Stepper
Motors (M16 and M17)
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Do REP 2.21
Module.
Drive Roller Replacement – Steering Module
remove the Steering Drive Roller corresponding to the motor you
are replacing.
5. Remove the Pulley from the motor shaft by loosening the set screw.
Set aside the Pulley and Drive Belt.
6. Disconnect the Motor Cable from the corresponding Stepper Driver
Board.
7. Disconnect the Motor by removing the M3 Screws (4), and remove
the Motor from the Steering Module.
Summary of Contents for StreamWire
