Repairs/Adjustments
07/23/2020
GBC StreamWire
4-26
REP 2.15 Alignment Sensor Replacement, S12, S13 & S15
PARTS LIST ON PL 5.2
Use the following procedures to remove and install the Alignment Sensors
(S12, S13, and S15). The Alignment Sensors are located on the
Alignment Sensor PCB (7715694).
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Do REP 1.1
4. Locate the Alignment Sensor PCB on the Bypass Panel.
5. Disconnect the Cable Connector from the PCB.
6. Release the Alignment Sensor PCB by removing the M3 Nuts (2)
7. Remove the old Alignment Sensor PCB from the Upper Bypass.
Installation Procedure
1. Place the new Alignment Sensor PCB onto the Upper Bypass by
aligning it with the M3 studs. Ensure that S12 is oriented at the rear
of the machine and S15 is oriented at the front of the machine.
2. Use the notch on the Alignment Sensor PCB mounting bracket to
align the sensor board with the notch on the eWire.
3. Tighten the M3 Nuts to secure the PCB.
4. Connect the Sensor Cable to the PCB.
5. Do REP 1.1
6. Connect the Power Cord.
7. Power ON the eWire.
Summary of Contents for StreamWire
