GBC StreamWire
7/23/2020
Repairs/Adjustments
4-35
Installation Procedure
1. Insert the new Stepper Motor into the Frame and secure it using the
M3 Screws (4).
2. Connect the Motor Cable to the corresponding Stepper Driver
Board.
3. Slide the Pulley and Belt onto the Motor shaft and secure the Pulley
using the set screw.
Drive Roller Replacement – Steering Module
the Steering Drive Roller Assembly.
Module.
6. Connect the Power Cord.
7. Power ON the eWire.
REP 2.23 Alignment Motor Replacement, M18
PARTS LIST ON PL 5.3
Use the following procedures to remove and install the Alignment Stepper
Motor (M18). The Alignment Stepper Motor moves the entire Steering
Module.
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Do REP 2.21
Module.
4. Remove the Motor Cable from the corresponding Stepper Driver
Board.
5. Loosen the M4 Screws (4) securing the Alignment Motor, and shift
the motor towards the center of the Steering Module to reduce
tension on the Motor Belt.
6. Remove the Pulley from the Motor shaft by loosening the set screw
and sliding the Pulley off the shaft.
7. Disconnect the Motor by removing the M3 Screws (4), and remove
the Motor from the Steering Module.
Summary of Contents for StreamWire
