Fuji Xerox ApeosPort-II C3300, User Manual

Page: 482 / 635

15 Problem Solving
480
Problem Solving
15
016-717
O [Cause] Unable to create a transmission report (undelivered) or
transmission report because transmission result
information required for creating the report is not stored in
the machine's memory.
[Remedy] Take one of the following actions:
z
Execute the jobs for large size iFax documents (about
2GB) by splitting each document to minimize memory or
HDD usage.
z
After the job that you want to check in a report is
completed, do not execute 200 or more jobs to have the
job recorded on a report.
016-718
O [Cause] Unable to process the PCL print data due to insufficient
memory.
[Remedy] Reduce the resolution, or cancel 2-sided printing or N up,
and then print again.
016-719
O [Cause] Unable to process the PCL print data due to insufficient
print page buffer.
[Remedy] Increase the size of the print page buffer.
016-720
O [Cause] An invalid command is included in PCL print data.
[Remedy] Check the print data and try to print again.
016-721 O O [Cause] An error occurred during print processing. Probable
causes are as follows:
1. Printing was instructed by [automatic tray selection]
when [Paper Type Priority] is set to [Automatic Tray
switching Off] for all paper in the [Common Settings].
2. ESC/P command error
[Remedy] For Cause 1: When printing by automatic tray selection,
set one of the paper types to a setting other than
[Automatic Tray switching Off] in [Paper Type Priority].
For Cause 2:Check the print data.
Refer to "Paper Type Priority" (P.278).
016-722 O [Cause] The specified staple position or the specified paper size is
not supported in the finisher.
[Remedy] Check the staple position and the paper size, and try to
print again.
016-723 O [Cause] The specified punch position or the specified paper size is
not supported in the finisher.
[Remedy] Check the punch position and the paper size, and try to
print again.
016-724
O [Cause] The specified staple and punch position combination is
unsupported.
[Remedy] Specify the staple and punch positions to be on the same
side, and try to print again.
016-725
O [Cause] A scanned document stored in a mailbox was to be sent by
fax using the Job Flow feature, but the mailbox document
could not be converted to fax data.
[Remedy] Do not use the Job Flow feature. Simply scan the
document through the machine's [Fax] screen to send it by
fax.
Error Code
Category
Cause and Remedy
C P F S M O
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.