Fuji Xerox ApeosPort-II C3300, User Manual

Page: 136 / 635

4 Fax
134
Fa
x
4
• You can only use the Delivery Receipts (DSN) feature to check the delivery of e-mail to
servers that support this feature. Furthermore, if any of the e-mail servers on the
transmission route do not support DSN, you cannot confirm the delivery of the e-mail, even if
the e-mail has been delivered successfully. For this reason, the result of the Delivery
Receipts may differ from the actual delivery status.
• If [Transmission Report] is activated and the transmission completes unsuccessfully,
[Transmission Report - Undelivered] will be printed.
This section describes how to use the MDN feature. The procedure is the same for the
DSN feature.
1
Select the [Fax/Internet Fax] tab to
display the [Fax/iFax Address]
screen.
2
Select [iFax/Fax] to display [iFax] in
the recipient section.
3
Select the [Transmission Options]
tab to display the [Transmission
Options] screen.
4
Select [Report/Read Receipts].
5
Select any item.
„ Transmission Report
z
Off
No Transmission Report is printed.
z
ON
A Transmission Report is automatically printed when the transmission completes
successfully. If the transmission does not end successfully, a Transmission Report -
Undelivered is printed.
„ Read Receipts
z
Off
The Read Receipts feature is not activated.
z
On
The Read Receipts feature is activated. You can check whether the iFax you sent was
delivered to the recipient's mailbox successfully.
Communication Mode (Selecting a Communication Mode)
You can select a communication mode based on the features of the remote machine.
G3 is the international standard for facsimile transmissions established by the ITU-T.
Important • When the speed dialing, one touch buttons, group dialing numbers, or address book is used
to specify a recipient registered in an address number, the communications mode currently
set to the address number is set and cannot be changed. For information on how to register
address numbers, refer to "Address Book (Address Number)" (P.334).
Note • The communication mode default value can be changed in the System Administration mode.
For information on how to change the default values, refer to "Communication Mode"
(P.314).