Club Car IntelliTach XRT 1550, Maintenance And Service Manual

Page: 87 / 564

HYDRAULIC AND PARK BRAKE SYSTEMS Park Brake System
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual Page 6-27
6
5. Route the cable end to the outside of the air intake hose.
6. Secure the cable to the frame bracket at the outside hole (Figure 6-22, Page 6-26) .
7. Insert the threaded end of the cable through the frame bracket. Use the nuts to adjust the cable end. Both
cables should be equal in length. Tighten the nuts to 40 ft-lb (54 N·m).
8. Secure the cable to the frame with a nylon wire tie.
9. Secure cable end to the equalizer bracket.
Left Rear Cable Installation
1. Install the caliper end of the cable into the brake caliper arm (Figure 6-21, Page 6-26) .
2. Slide the sheath ferrule through the hole in the caliper mounting bracket.
3. Install a C-clip to hold the cable ferrule in place.
4. Route the cable to the inside of the air intake hose.
5. Secure the cable with a P-clamp and nylon wire tie to the frame.
6. Secure the cable end to the equalizer bracket. See Park Brake Equalizer Installation on page 6-28.
FRONT PARK BRAKE CABLE REMOVAL
1. Chock the rear wheels and release the park brake.
2. Remove the spring from the driver side equalizer adjustment rod (Figure 6-24, Page 6-28) .
3. Remove the nuts from the threaded adjustment rod on the cable end.
4. Release the tines securing the cable ferrule to the frame bracket.
5. Reach under the driver side instrument panel, remove the cotter pin and disconnect the front park brake
cable end from the lower-most park brake bell crank (Figure 6-25, Page 6-28) .
6. Turn the steering wheel fully to the right to allow access in the wheel well area behind the driver side front
wheel.
7. Reach under the driver side wheel well area behind the front wheel and remove the outboard hex-head
bolt securing the plastic splash panel.
Figure 6-23 Air Filter and Park Brake Cable Clamp