Club Car IntelliTach XRT 1550, Maintenance And Service Manual

Page: 410 / 564

HONDA GASOLINE ENGINE, MUFFLER, FUEL SYSTEM, AND CLUTCHES Engine Control Linkages
Page 13b-20 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
13B
4. Remove the spring end of the cable from the engine bracket (Figure 13b-19, Page 13b-20) .
5. Slide the cable away from the throttle control wire loop. See following NOTE.
NOTE: Note the position of the small washer between the throttle wire loop and the spring/cable attach-
ment.
6. Remove the cable sheath strain relief from the engine bracket and remove the governor cable.
Governor Cable Installation
ý
WARNING
• If the governor cable is removed or replaced, the governor system must be adjusted. See
Ground Speed (Transmission) Governor Arm Adjustment on page 13b-21. Also See High-
Speed RPM Adjustment on page 13b-24. Incorrect adjustment may result in severe personal
injury or death.
1. Secure the spring loop on the engine end of the cable to the engine bracket (Figure 13b-19,
Page 13b-20) .
2. Slide the cable into the throttle wire loop. Ensure the small washer is positioned between the throttle wire
loop and the cable/spring attachment.
3. Secure the cable sheath to the engine bracket.
4. Secure the Z-shaped end of the governor cable to the governor arm on the transmission.
5. Secure the cable sheath to the transmission bracket.
6. Install the governor guard. See Governor Guard Installation on page 13b-19.
ACCELERATOR CABLE RETENTION CLIP ADJUSTMENT
NOTE: The accelerator strain relief retention clip must be adjusted if the accelerator pedal, accelerator
cable or governor cable was removed, or if the engine idle is too high.
1. Release the cable sheath retention clip (Figure 13b-13, Page 13b-17).
Figure 13b-18 Governor Cable on Transmission Figure 13b-19 Governor Cable on Engine