Club Car IntelliTach XRT 1550, Maintenance And Service Manual

Page: 469 / 564

2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual Page 14-1
14
SECTION 14 – DRIVETRAIN COMPONENTS
ý
DANGER
• See General Warning, Section 1, Page 1-1.
ý
WARNING
• See General Warning, Section 1, Page 1-1.
This Section contains information on removing and installing the front differential, transmission, and rear dif-
ferential. Refer to the appropriate manual for complete instructions on disassembly, repair, rebuilding, and
reassembly.
See the Engines and Drivetrain Components manual (CCI P/N 102396501).
HALF SHAFTS
HALF SHAFT REMOVAL
1. Turn the key switch OFF and remove the key. Set the park brake. Place the Forward/Reverse handle in
NEUTRAL. Chock the rear wheels.
2. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning, Section 1, Page 1-2.
3. Loosen the lug nuts on both front wheels.
4. Remove the rubber spindle nut covers from both front wheels.
5. Loosen the spindle nuts and lift the front of the vehicle with a chain hoist or floor jack. See WARNING
“Lift only one end...” in General Warning, Section 1, Page 1-2.
6. Place jack stands under each end of the floor crossmember and lower vehicle onto stands (Figure 14-1,
Page 14-1) .
7. Remove both front wheels.
Figure 14-1 Place Jack Stands Under Crossmember Figure 14-2 Axle Spindle Nut And Washer