TROUBLESHOOTING AND ELECTRICAL SYSTEM: DIESEL VEHICLES
Test Procedures
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
Page 11c-51
11C
TEST PROCEDURE 34 – BED LIFT MOTOR
NOTE:
Keep the battery connected during this test procedure.
Ensure that the battery is fully-charged before performing this test procedure.
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Disconnect the red and yellow wires from the bed lift motor
(Figure 11c-48, Page 11c-51)
.
3. Set a multimeter for 20 VDC.
4. Place the red probe in the bullet connector on the red wire (wire harness side) and place the black probe
in the bullet connector on the black wire (wire harness side)
(Figure 11c-49, Page 11c-51)
.
5. Have an assistant press the bed lift switch in the UP position and monitor the multimeter:
•
A reading of approxi (positive) 12 VDC indicates that the bed lift harness and switch are wired
correctly. Proceed to step 6.
Figure 11c-47 Voltage At Headlight Socket
Figure 11c-48 Bed Lift Motor Wires
Figure 11c-49 Bed Lift Motor Voltage Reading with
Switch in UP position
Figure 11c-50 Bed Lift Motor Voltage Reading with
Switch in DOWN position
2m
20
m
200
m
2k
200
200
200
200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK
5XL
V
V
V
A
!
!
COM
200nA
MAX
1000 ---
750V
FUSED
BLACK WIRE
BLUE WIRE
WIRE HARNESS
Summary of Contents for IntelliTach XRT 1550
