Club Car IntelliTach XRT 1550, Maintenance And Service Manual

Page: 417 / 564

HONDA GASOLINE ENGINE, MUFFLER, FUEL SYSTEM, AND CLUTCHES Choke and Air Intake System
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual Page 13b-27
13B
6. Remove the two bolts and park brake cable from the canister and remove the canister.
AIR CANISTER INSTALLATION
1. Position the canister next to the frame bracket with the rubber valve down.
2. Install two bolts to secure the canister base bracket and vehicle frame bracket. Tighten the hardware to
21 ft-lb (28.5 N·m).
3. Secure the bottom (inlet) hose to the canister port.
4. Secure the top (outlet) hose to the canister port.
5. Install a new air filter cartridge. See Air Filter Installation on page 13b-25.
6. Connect the battery cables, positive (+) cable first, and tighten the hardware to 144 in-lb (16 N·m). Coat
terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
AIR FILTER INTAKE HOSE REMOVAL
The air filter intake hose fits between the driver-side frame and the inlet port on the air filter canister. The
frame serves as a duct to carry air from a location at the top of the front of the vehicle.
ý
CAUTION
• Do not drill holes or attach anything to the driver side of the frame. A penetrating fastener will
create passages that could allow moisture and/or dirt to enter the engine air intake system.
1. Turn the key switch OFF and remove the key. Set the park brake. Place the Forward/Reverse handle in
NEUTRAL.
2. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning, Section 1, Page 1-1.
3. Remove the hose from under the filter canister.
4. Remove the hose from under the vehicle body on the frame.
5. Slide the hose through the frame support bracket and remove the hose from the vehicle (Figure 13b-27,
Page 13b-28) .
Figure 13b-26 Air Filter Canister