Club Car IntelliTach XRT 1550, Maintenance And Service Manual

Page: 294 / 564

ELECTRICAL COMPONENTS: KAWASAKI POWERED GASOLINE VEHICLES Voltage Regulator
Page 12a-4 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
12A
Carburetor Heater Installation
1. Install the carburetor heater and tighten to 65 in-lb (7 N·m).
2. Connect the green wire to the heater (Figure 12a-4, Page 12a-4) .
3. Install the engine top cover.
4. Connect the battery cables, positive (+) cable first, and tighten the terminals to 144 in-lb (16 N·m). Coat
terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
VOLTAGE REGULATOR
See General Warning, Section 1, Page 1-1.
Testing the Voltage Regulator
See Test Procedure 14, Section 11a, Page 11a-26.
Voltage Regulator Removal
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally...” in General
Warning, Section 1, Page 1-2.
3. Disconnect the multi-pin connector and the yellow and green wires from the voltage regulator
(Figure 12a-5, Page 12a-5) .
4. Remove the voltage regulator mounting screw and remove the voltage regulator.
Voltage Regulator Installation
1. Position the voltage regulator on the mounting plate and install the mounting screw. Tighten screw to 30
in-lb (3.4 N·m) (Figure 12a-5, Page 12a-5) .
2. Connect the multi-pin connector and the yellow and green wires to the voltage regulator.
3. Connect the battery cables, positive (+) cable first, and tighten the terminals to 144 in-lb (16 N·m). Coat
terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
Figure 12a-4 Carburetor Heater
1