Club Car IntelliTach XRT 1550, Maintenance And Service Manual

Page: 151 / 564

PERIODIC MAINTENANCE: KAWASAKI GASOLINE & KUBOTA DIESEL POWERED VEHICLESHydraulic System – Intellitach Ve-
hicle
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual Page 10b-15
10B
HYDRAULIC SYSTEM – INTELLITACH VEHICLE
ý
WARNING
• Diesel fuel or hydraulic fluid under pressure can penetrate skin or eyes, causing serious
injury or death. Fluid leaks under pressure may not be visible. Use a piece of cardboard or
wood to find leaks. Do not use your bare hand. Wear safety goggles. If fluid enters skin or
eyes, get immediate medical attention from a physician familiar with this injury.
Inspect the hydraulic fluid level daily.
Use only recommended fluid in the hydraulic system. See IntelliTach Specifications, Section 2b,
Page 2b-5.
1. Lift the cargo box.
2. Turn the start key to the ON position but DO NOT start the engine.
3. Press the joystick ON/OFF switch to ON.
4. Move the joystick (1) back and raise the attachment arm fully (Figure 10b-19, Page 10b-15) .
5. Move the joystick (1) to the right and tilt the attachment interface fully in.
6. Press the auxiliary hydraulic rocker switch (2) so that the cylinders are retracted. (If equipped with aux-
iliary hydraulics).
7. Turn the key to the OFF position.
8. The hydraulic oil level must be between the Maximum Fluid Level and the Minimum Fluid Level lines on
the hydraulic tank (Figure 10b-20) .
9. If hydraulic oil must be added, thoroughly clean the area around the fill cap. Remove the fill cap and add
hydraulic fluid until it is between the Maximum Fluid Level and the Minimum Fluid Level lines.
Figure 10b-19 Joystick Figure 10b-20 Hydraulic Fluid Tank, Pump and Con-
trol Valves
10
28
49
80
1
AUX HYD
FLOAT
ACTIVATE
TOGETHER
FOR FLOAT
1