Club Car IntelliTach XRT 1550, Maintenance And Service Manual

Page: 546 / 564

HYDRAULIC ATTACHMENT SYSTEM Hydraulic Pump Assembly
Page 16-48 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
16
MOTOR
Motor Removal
1. Lift pump assembly out of chassis and remove cradle. See Pump Assembly Removal on page 16-44.
2. Note location of and disconnect solenoid wires and remove solenoid.
3. Make a mark from the motor housing to ease reassembly alignment.
4. Remove two bolts and end cover from motor (Figure 16-93, Page 16-48) .
5. Grasp motor housing and armature and pull motor from pump. See following NOTE.
NOTE: The motor may require effort to remove because the bearing is also being pulled out of the base
(Figure 16-94, Page 16-48) .
Motor Installation
1. Align slot in motor armature with pump driveshaft and carefully push the motor and bearing into place
(Figure 16-95, Page 16-49) (Figure 16-96, Page 16-49) . Once in place, align mark on motor housing
with mark on base.
2. Align hole in end cover with pin on motor housing and install. Secure with bolts previously removed.
3. Attach solenoid to motor and connect wires. See Solenoid Installation on page 16-20.
4. Assemble pump assembly to cradle and place unit in chassis. See Pump Assembly Installation on
page 16-46.
Figure 16-93 Remove Motor Bolts Figure 16-94 Motor Bearing