Club Car IntelliTach XRT 1550, Maintenance And Service Manual

Page: 127 / 564

PERIODIC MAINTENANCE: HONDA GASOLINE & KUBOTA DIESEL POWERED VEHICLES Engine Oil
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual Page 10a-9
10A
2. Disconnect the battery cables, negative (–) cable first. See WARNING “To avoid unintentionally start-
ing...” in Section 1 – Safety on page 1-2.
3. Remove the oil filler cap to allow the oil to drain properly.
4. Position a pan designed for oil changes under the drain plug (1) (Figure 10a-8, Page 10a-9 or
Figure 10a-10, Page 10a-10) .
5. From the underside of the vehicle, use a 14 mm socket or wrench to remove the drain plug (1). Turn the
plug counterclockwise and drain the engine oil into the pan. See following WARNING.
ý
WARNING
• Do not attempt to change engine oil when the engine is hot or even warm. Hot engine oil can
cause skin burns.
• Wear safety glasses or approved eye protection when servicing the vehicle. Wear rubber
gloves when handling oil drain plug, oil filter, and oil drain pan.
6. Clean the oil drain plug threads with solvent to remove oil and oil residue. Make sure that the compres-
sion washer remains on the drain plug. Inspect the compression washer and replace if necessary.
7. Use a 14 mm socket or wrench to replace the oil drain plug. Turn the plug clockwise and tighten to 29
ft-lb (40 N·m) for gasoline vehicles, 31 ft-lb (42 N·m) for diesel vehicles.
Figure 10a-8 Engine Oil Drain Plug and Pan –
Gasoline Vehicles
Figure 10a-9 Replace Engine Oil Filter –
Gasoline Vehicles
1
2