Avaya IP Office Phone Manager, Installation Manual, Page: 90 / 411

IP Office Installation Page 89
15-601042 Issue 20b (16 July 2009) IP Office
IP500 Basic Installation: Connecting the Manager PC (IP500)
5.9 Start Manager
At this stage we will simple check that Manager is able to run and to see the
connected IP Office control unit.
Procedure: Receiving the Configuration
1. Select Start | Programs | IP Office | Manager .
2. If the PC has firewall software installed, you should be prompted as to whether you want to allow this program to
access the network. Select Yes or OK .
3. Click in the main toolbar or select File | Open Configuration from the menu bar.
4. The Select IP Office window appears. After a few seconds it should list the control unit that is being setup. The
default name used is the control units MAC address.
•
If the system required was not found, the address used for the search can be changed. Enter or select the
required address in the Unit/Broadcast Address field and then click Refresh to perform a new search.
5. Click the check the box next to the system and then click OK .
6. The name and password request is displayed. The name and password must match one of those setup through the
security settings. The default name and password for full configuration settings access is Administrator and
Administrator.
7. Successful receiving of the configuration is shown by the full configuration tree being shown in the left-hand panel.
With no configuration loaded the navigation pane shows just BOOTP and Operator entries.