Avaya IP Office Phone Manager, Installation Manual, Page: 23 / 411

IP Office Installation Page 22
15-601042 Issue 20b (16 July 2009) IP Office
2.6 IP500 Trunk Cards
Updated for IP500 PRI-U trunk daughter card. Need to add accurate picture of card and also update fitting picture for the
new pillar arrangment.
IP500 daughter trunk cards can be fitted to IP500 base cards to
provide support for trunk. The daughter card uses the physical ports
provided on the front panel of the base card for cable connection.
The addition of an IP500 daughter card is supported on any IP500
base card except the IP500 Legacy Card Carrier base card.
For those base card that support daughter cards, there are no
restrictions on the combination of card types. However in systems
with both analog phone base cards and analog trunk daughter cards,
combining the two type is recommended as it then provides analog
power failure support for one trunk/extension.
Each daughter card is supplied with the stand off pillars required for
installation and a label to identify the cards presence on the physical
unit once installed.
•
Note: Change to Installation
With the introduction of the IP500 PRI-U trunk daughter card, the
5 plastic stand off pillars supplied with these card were changed.
All trunk daughter cards are now supplied with two pre-fitted
metal pillars and 3 plastic pillars. Two screws and washers for final
attachment of the metal pillars to the base card are also included.
This change does not affect existing cards supplied with 5 plastic
pillars.
IP500 Analog Trunk Daughter Card This card can be added to an IP500 base card except the IP500
Legacy Card Carrier base card. It allows that base card to then also
support 4 analog loop-start trunks.
•
When fitted to an IP500 Analog Phone 8 base card, the
combination supports 1 power failure extension to trunk
(loop-start only) connection.
•
Maximum: 4 per IP500 control unit.
IP500 BRI Trunk Daughter Card This card can be added to an IP500 base card except the IP500
Legacy Card Carrier base card. It allows that card to then also
support up 4 BRI trunk connections, each trunk providing 2B+D
digital channels. The card is available in 2 port (4 channels) and 4
port (8 channels) variants.
•
Maximum: 4 per IP500 control unit.
•
S-Bus Connection: On IP Office 4.2+ systems, the card can be
switched from To trunk mode to So mode. This mode requires
additional terminating resistors and an ISDN crossover cable
connection, see
BRI Port (So) .
IP500 PRI-U Trunk Daughter Card This card can be added to an IP500 base card except the IP500
Legacy Card Carrier base card. The card is a universal card that can
be configured in software for E1 PRI, T1 robbed bit, T1 PRI or E1R2.
The card is available in single and dual port variants.
•
Maximum: 4 per IP500 control unit.
•
The IP500 PRI-U card supports E1, T1 and E1-R2 PRI modes. The
IP Office system supports 8 unlicensed B-channels on each IP500
PRI-U port fitted. Additional B-channels, up to the capacity of
ports installed and PRI mode selected require
IP500 Universal
PRI (Additional Channels) licenses added to the configuration.
These additional channels consume the licenses based on which
additional channels are configured as in-service from port 9 of slot
1 upwards. D-channels are not affected by licensing.