Avaya IP Office Phone Manager, Installation Manual, Page: 117 / 411

IP Office Installation Page 116
15-601042 Issue 20b (16 July 2009) IP Office
6.5 Receiving a Configuration (Pre 3.2)
The following is the normal procedure for receiving a copy of the IP Office configuration from a new or defaulted control
unit running pre-3.2 IP Office core software.
Objective - This process tests the communication between the Manager application and the IP Office control unit.
Information Required
1. o System Password - For a new or defaulted system this is password.
Procedure: Receiving the Configuration from a Pre-3.2 IP Office Control Unit
1. Select Start | Programs | IP Office | Manager .
2. Click in the main toolbar or select File | Open Configuration from the menu bar.
3. The Select IP Office window appears. After a few seconds it should list the control unit that is being setup. The
default name used is the control units MAC address.
•
If the system required was not found, the address used for the search can be changed. Enter or select the
required address in the Unit/Broadcast Address field and then click Refresh to perform a new search.
4. Click the check the box next to the system and then click OK .
5. The name and password request is displayed. The name must match a Manager operator and the password must
match the IP Office control unit's system password. For a defaulted IP Office with pre-3.2 IP Office software enter
Administrator and password .
6. The name and password used above are applicable to new control units which are supplied with a basic IP Office
2.1 level of software. Once upgraded to IP Office 3.2 the name and password required change.
7. Successful receiving of the configuration is shown by the full configuration tree being shown in the left-hand panel.
With no configuration loaded the configuration tree shows just BOOTP and Operator.