Avaya IP Office Phone Manager, Installation Manual, Page: 138 / 411

IP Office Installation Page 137
15-601042 Issue 20b (16 July 2009) IP Office
IP400 Basic Installation: Configuring Security Settings
6.16 Receiving a Configuration (3.2+)
The process here applies to systems running IP Office 3.2 and higher.
Objective - Receive a configuration from an IP Office running IP Office 3.2 or higher software.
Information Required
•
o
Service User Name and Password
The defaults for full configuration access are Administrator and Administrator. However these should have been
changed as part of the installation process, see
16. Configuring Security Settings .
Procedure: Receiving the Configuration
1. Select Start | Programs | IP Office | Manager .
2. Click in the main toolbar or select File | Open Configuration from the menu bar.
3. The Select IP Office window appears. After a few seconds it should list the control unit that is being setup. The
default name used is the control units MAC address.
•
If the system required was not found, the address used for the search can be changed. Enter or select the
required address in the Unit/Broadcast Address field and then click Refresh to perform a new search.
4. Click the check the box next to the system and then click OK.
5. The name and password request is displayed. The name and password must match one of those setup through the
security settings. The default name and password for full configuration settings access is Administrator and
Administrator.
6. Successful receiving of the configuration is shown by the full configuration tree being shown in the left-hand panel.
With no configuration loaded the navigation pane shows just BOOTP and Operator entries.
IP Office Default Settings
The following are the basic default configuration settings for an IP Office system.
System Name MAC address of the control unit.
System Password password
License Server IP Address 255.255.255.255
LAN1 LAN1 LAN2/WAN
IP address 192.168.42.1. 192.168.43.1
IP Mask 255.255.255.0 255.255.255.0
DHCP Mode Server Server
No of DHCP IP Addresses 200. 200.
•
Extensions and Users
A user is automatically created for each physical extension port detected in the system. Users are assigned
extension numbers starting from 201. User names take the form Extn201, Extn202, ....
•
Hunt Group
A single hunt group 200 called Main is created and the first 10 users are placed into that hunt group as members.
•
Incoming Call Routes
Two default incoming call routes are created. Voice calls are routed to the hunt group Main. Data calls are routed
to the RAS user DialIn.