Avaya IP Office Phone Manager, Installation Manual, Page: 213 / 411

IP Office Installation Page 212
15-601042 Issue 20b (16 July 2009) IP Office
Ports Description
AUDIO 3.5mm Stereo jack socket. Used for external music on hold source input.
ANALOG Used for connection of external analog trunks. Loop-start only.
DC I/P DC power input port. Used for connection of the power lead from an Avaya earthed 60W external power
supply unit supplied with the control unit.
DS Digital Station port. Used for connection of IP Office supported DS phones . Not suitable for out-of-building
extensions.
DTE 9-Way D-Type socket. Used for system maintenance. Suitable for direct connection of IP Office Serial Port
Feature Key dongle.
EXT O/P 3.5mm Stereo jack socket. Used for switching external relay systems such as door entry controls. The port
contains two independent switches controlled by the IP Office.
LAN RJ45 socket. These ports form an unmanaged layer 2 Ethernet switch. The ports are full-duplex
10/100Mbps auto-sensing, auto-MDI/MDIX ports.
PCMCIA Dual PCMCIA card slot. Used for optional Embedded Voicemail card and wireless access point card. Cards
are not hot-swappable and order of slot usage is not significant.
PHONE RJ45 socket. Used for connection of analog phones. Intended for two-wire analog phones. For connection to
4-wire analog phones connection should be via a master socket with ringing capacitors. During power
failure, PHONE port 1 is directly connected to ANALOG trunk port 2. Not suitable for out-of-building
connections.
•
On some older Small Office Edition control units, these ports are labeled as POT rather than PHONE.
WAN RJ45 socket. 10/100Mbps Ethernet LAN port. Acts as LAN2 within the configuration.
3.5mm Jack socket. Function ground point. Used for connection of a function or protective ground . Use of a
ground for all systems is recommended and for some locales may be a regulatory requirement.
All control units are available in either North America or Rest of World variants. The choice controls various default
settings of the unit. For E911 support a North American variant control unit must be used. The companding can be
changed once a unit is installed.
Item Variant Country SAP Code
Small Office Edition 4T+4A+8DS
(3 VoIP) A-Law Rest of World 700280209
U-Law North America 700350424
Small Office Edition 4T+4A+8DS
(16 VoIP) A-Law Rest of World 700280217
U-Law North America 700350432
IEC60320 C13 Power Cord CEE7/7 Europe 700289762
BS1363 United Kingdom 700289747
NEMA5-15P America 700289770
China China 700261977
Rack Mounting Kit All 700210800
Control units are supplied with an external power supply unit but not a locale specific power cord.