5-6
Section
Creating and Transferring Data with the Support Tool
113
The work bit 23500 is used to begin reading. When debugging, it is a good idea
to create a ladder program that refers to the ER Flag and Error Flag (word n+8,
bit12).
Contents of DM after read is completed.
1
DM0500
0
0
0
Speed #0
5
DM0501
5
0
0
Speed #1
Read switch.
Set the beginning address (transfer origin) for the speed
to be read from the Position Control Unit at 1300.
Set the transfer origin unit number to 2, and the number
of transfer words to 2.
Set the beginning word for the area on the PC where
the read data is to be stored (the transfer destination)
to D0500.
If the transfer is completed successfully, work bit 23502
will turn ON.
DIFU (13)
23500
IORD
#1300
#2002
D0500
23500
23501
23502
23502
23501
25506
END
(01)
5-6
Creating and Transferring Data with the Support Tool
If this Unit is installed on a C200HX/HG/HE-series PC, it will be possible to use
the SYSMAC-NCT Support Tool to read, write and save data, and to monitor the
operating status of the Position Control Unit.
The SYSMAC-NCT Support Tool is software that runs under Windows 95 and
can be used for setting all kinds of data used by a Position Control Unit as well as
for monitoring the operating status of the Position Control Unit.
Refer to the
SYSMAC-NCT Support Tool Operation Manual
for details on its
operation.
Note
Do not carry out multiple transfers from SYSMAC-NCT Support Tool to the same
Position Control Unit at the same time. There is a probability of the data transfer
not being completed successfully, and of abnormal operation resulting.
Be sure that the Position Control Unit which is using SYSMAC-NCT Support
Tool to carry out data transfer and storage, and monitor the status of operations,
is mounted on the PC’s CPU Rack or an Expansion I/O Rack. Access is not avail-
able to a Position Control Unit mounted to a Slave.
Note
When setting the sequence data using the SYSMAC-NCT Support Tool, more
than one axis designation cannot be made for one sequence data number. If
more than one axis designation is made for one sequence data number, an Axis
Designation Error will occur.
For example, an Axis Designation Error will occur in the following cases;
Axis designation of “XY” for the X-axis sequence data No. 100
Axis designation of “Y” for the Y-axis sequence data No. 100.
Program Example
Outline
Creating and
Transferring Data
Содержание C200HW
