![background image](http://html1.mh-extra.com/html/omron/c200hw/c200hw_operation-manual_742329084.webp)
4-1
Section
Overall Structure
71
Sequence #98
X axis 1294 (NC113), Y axis 2294 (NC213), Z axis 3294 and U axis 4294
(NC413)
Same as for sequence #0.
Default setting: 0000, 0000, 0000
Sequence #99
X axis 1297 (NC113), Y axis 2297 (NC213), Z axis 3297 and U axis 4297
(NC413)
Same as for sequence #0.
Default setting: 0000, 0000, 0000
Note
When setting the sequence data using the SYSMAC-NCT Support Tool, more
than one axis designation cannot be made for one sequence data number. If
more than one axis designation is made for one sequence data number, an Axis
Designation Error will occur.
For example, an Axis Designation Error will occur in the following cases;
Axis designation of “XY” for the X-axis sequence data No. 100
Axis designation of “Y” for the Y-axis sequence data No. 100.
Speed #0
X axis 1300 (NC113), Y axis 2300 (NC213), Z axis 3300 and U axis 4300
(NC413)
15
00
Factor
x10
3
x10
2
x10
1
x10
0
14
13
12
This data sets speed #0. The permissible setting range is 0 to 1,000,000 (pps) in
the following combination. The two leftmost bits are used for setting the factor.
Factor: 00: x1; 01: x10; 10: x100; 11: x1,000
Speed: 0 to 3,999
Default Setting: 0000
Speed #1
X axis 1301 (NC113), Y axis 2301 (NC213), Z axis 3301 and U axis 4301
(NC413)
The settings are the same as for speed #0.
Default Setting: 0000
Note
The word addresses continue in order for all four axes from speed #2 through
speed #97, which are not listed in detail here.
Speed #98
X axis 1398 (NC113), Y axis 2398 (NC213), Z axis 3398 and U axis 4398
(NC413)
The settings are the same as for speed #0.
Default Setting: 0000
Speed #99
X axis 1399 (NC113), Y axis 2399 (NC213), Z axis 3399 and U axis 4399
(NC413)
The settings are the same as for speed #0.
Default Setting: 0000
Содержание C200HW
