Installation and Startup Guide
This document covers the installation of MT600iWP Series HMI, for the detailed specifications and
operation, please refer to Datasheet and MT600iWP
User Manual.
Install Environment:
NEMA Rating
MT600iWP
HMI is NEMA 4X rated.
Electrical
Environment
The
MT600iWP
Series has been tested to conform to European CE
requirements. This means that the circuitry is designed to resist the effects of
electrical noise. This does not guarantee noise immunity in severe cases. Proper
wire routing and grounding will insure proper operation.
Environmental
Considerations
(1) Make sure that the displays are installed correctly and that the operating
limits are followed Avoid installing units in environments where severe
mechanical vibration or shocks are present.
(2)
Do not operate the unit in areas subject to explosion hazards due to
flammable gases, vapors or dusts.
(3) Do not install the unit where acid gas, such as SO2 exists.
(4)
This device should be mounted in the vertical position and for use on the flat
surface enclosure.
(5)
Conform to UL508 (ISBN 0-7629-0404-6) machine safety for use in
Pollution Degree 2 Environment.
Unpacking the Unit
Unpack and check the delivery. If damage is found,
notify the supplier.
Installation Instructions
Secure the operator panel in position,
using all the fastening holes
and the provided brackets
and screws:
Power Connections
Settings Introduction
When HMI is ON, the relevant
system settings are accessible.
Type
A(mm)
B(mm)
MT605iWP
119
93
MT607iWP
192
138
MT610iWP
259
201
MT600iWP series
Installation Instruction
1
2
NOTE:
Place the operator panel on a stable
surface during installation. Dropping it or
letting it fall may cause damage.
3
(1) Installation Instruction, 2-sided A4 *1
(2) MT600iWP HMI *1
(3) Power Connector *1
(4) Brackets & Screws V2.1 *1 pack
(5) Fuse 1.25A/250V 5*20mm *1
5
4
NOTE:
1.
Connect positive DC line to the ‘+24V’
termin
al and the DC ground to the ‘0V' terminal.
2. Please do not connect HMI with PLC and PC
simultaneously to prevent potential difference
from destroying USB ports of HMI and PC.
To make a connection, strip about 3/8” of
insulation off the end of the wire, turn the
connector screw counterclockwise until the gap
is wide open, insert the wire all the way in, and
turn the screw clockwise until
it’s tight.
(A)
(B)
Cutout
( Note 1: For the details of HMI
DIP SW function settings please
refer to Part 8 in this guide. )
(1)
(2)
(5)
(4)
(3)
