1-1
Section
Features
3
The SYSMAC-NCT Support Tool can only be used to access PCUs mounted on
a CPU Rack or an Expansion I/O Rack. It cannot access PCUs mounted on
Slave Racks. The SYSMAC-NCT Support Tool cannot be used with
C200H/C200HS CPU Units.
The amounts of data that can be set for memory operation are shown in the fol-
lowing table:
Type of data
Number of data items per axis
Positioning sequences, speeds, positions
100
Acceleration times, deceleration times
9
Dwell times
19
Zones
3
These data items are transferred to the PCU for use. Once they have been trans-
ferred to the PCU they can be saved to the PCU’s flash memory, so there is no
need for battery maintenance.
Note
There is a limit to the service life of the flash memory. A total of up to 100,000 data
saving operations can be performed.
With C200HX/HG/HE-series Programmable Controllers, not only can data be
transferred by means of data transfer bits and SYSMAC-NCT Support Tool, but
high-speed data transfers can also be performed by means of the Intelligent I/O
Write (IOWR) and Intelligent I/O Read (IORD) instructions.
Data Capacity and
Backup
High-speed Data Transfer
Содержание C200HW
