![background image](http://html1.mh-extra.com/html/omron/c200hw/c200hw_operation-manual_742329096.webp)
4-4
Section
Operating Memory Area
83
Set mode 2 when using a servomotor driver and connecting a line driver input
and a error counter reset output just as in mode 1, but when also using a posi-
tioning completed signal.
IC
X axis
PCU
Pulses
24 VDC
OPI
PCSI
OS
DCRO
DCRI
Servo-
motor
driver
Z-phase
output
PCSO
Set mode 3 when using a servomotor driver and also using the origin adjustment
command.
IC
X axis
PCU
Pulse
24 VDC
OPI
PCSI
OACO
OACI
Servo-
motor
driver
PCSO
Note
In the wiring examples for modes 1 to 3, the servomotor driver used is an
OMRON R88D Servomotor Driver. Set the servomotor driver so that the servo-
motor driver’s positioning completed signal is OFF during motor operation and
ON while the motor is stopped. If this setting is not made, positioning may
become impossible without the positioning completed signal in the operating
memory area turning ON.
4-4
Operating Memory Area
The operating memory area is allocated to the Programmable Controller’s IR
area. The IR area addresses are determined when the Position Control Unit’s
unit number is set.
The operating memory area is divided into outputs and inputs. Commands
related to operations are allocated to the output memory area, and the com-
mands are sent to the Position Control Unit (PCU) when their respective bits are
turned ON, or at the rising edge (
↑
) when the bits are turned ON.
The PCU’s status and present position are input from the PCU to the input area.
The operating data area exchanges data with the PCU with every I/O refresh, so
operating commands and so on can be executed simply by writing to the Pro-
grammable Controller’s IR area.
Note
If the CCW limit setting is equal to or greater than the CW limit setting in the axis
parameters area, and if the software limits are disabled, the present position will
be “0” when memory operation or direct operation is started.
Mode 2
Mode 3
Содержание C200HW
