DESCRIPTION
Applications
: The BadgerTouch® Single Remote Module coupled
with the High Resolution Encoder (HRE) or Absolute Digital Encoder
(ADE®) is a complete electronically encoded close-proximity
automated meter reading system, specifically designed for single
point remote meter installations. This system can be used with all
currently available Badger Meter Recordall® Disc, Turbo, Compound,
Combo, Fire Series meters and assemblies.
Communication
: Communication is accomplished by using
compatible reading devices programmed to read BadgerTouch
or Sensus protocols, such as the VersaProbe reading wands, to
interrogate the BadgerTouch remote module. The remote module
responds with its serial number, water meter reading, and transmits
data in approximately 2.5 seconds. In the event a tamper condition
exists, the data collector will not receive a reading.
Performance
: The Badger Meter BadgerTouch meter reading
system offers operating performance in a variety of applications
under most climatic conditions. For consistent results, interrogation
equipment should be placed in direct contact with the remote
read pad.
Meter Reading Validation
: Further validation of the meter
reading can be made automatically by the data collector based
on comparison of high-low audit fields in the record. If the meter
reading is not between these predetermined limits, an error
message is displayed on the data collector display.
Wire Connections
: The BadgerTouch Remote Module can be
installed in new or existing installations where remote meter
reading is required. The remote module is connected to the
recommended wire that runs between the module and the HRE
or ADE. A set of terminal screws on the remote module makes
this connection. The HRE or ADE is provided prewired with a
3', 6', 10' 15' or 25' length of wire that is ready for connection in
existing installations. Please see Figure 1 for more information
on connections. To provide best results, a maximum of 75 feet of
wire (Belden #9770) between the remote module and the encoder
is allowed. Other wire types may also affect performance. If an
additional length of wire is used in addition to that provided with
the encoder, a set of gel splices must be made.
Construction
: The Badger Meter BadgerTouch remote module
enclosure is constructed of a high impact plastic enclosure designed
for most remote locations. All internal electronic components are
encapsulated to provide environmental protection. The HRE and
ADE provide permanent glass/metal packaging in a plastic shroud
and lid for long lasting, highly reliable encoded meter reading
information collection.
License Requirements
: This device complies with Part 15 of the
FCC Rules. Operation of this device is subject to the following two
conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation. Any changes
made by the user not approved by Badger Meter can void the user’s
authority to operate the equipment. No license is required by the
utility to operate a BadgerTouch meter reading system.
SPECIFICATIONS
Operating
Temperature
–5…120° F (–20…49° C)
Storage Temperature
–5…120° F (–20…49° C)
Humidity
0% to 100% Condensing
Ultraviolet
Remote enclosure is UV protected for
outdoor installation.
Construction
The remote module has a high impact
weather proof plastic enclosure
containing encapsulated electronics
and reading coil. The HRE and ADE is
constructed of a permanently sealed
glass and copper corrosion-resistant
metal can design.
Hardware
Two terminal screws for connecting
the HRE or ADE lead wire to the
remote module.
Noncorrosive tamper resistant TORX®
seal screw mounted on the HRE or
ADE shroud and remote housing
(optional proprietary keyed seal screw
available).
Weight
6 ounces (not including the encoder)
BadgerTouch®
Automated Meter Reading System Remote Module
Models HREBT and ADEBT
BTA-DS-00233-EN-02 (June 2013)
Product Data Sheet
