Mitsubishi Electric FR-F800, Инструкция по эксплуатации

Страница: 676 / 834

(G) Control parameters Parameters
5 - 514
5.13 (G) Control parameters
Purpose Parameter to set
Refer
to
page
To set the starting torque manually Manual torque boost P.G000, P.G010 Pr. 0, Pr. 46 5-515
To set the motor constant
Base frequency, base
frequency voltage P.G001, P.G002,
P.G011
Pr. 3, Pr. 19, Pr. 47 5-517
To select the V/F pattern matching the
application
Load pattern selection P.G003 Pr. 14 5-519
To perform energy saving operation Energy saving operation P.G030 Pr. 60 5-521
To use a special motor Adjustable 5 points V/F
P.C100,
P.G040 to P.G049
Pr. 71,
Pr. 100 to Pr. 109
5-522
To compensate the motor slip amount
when replacing an SF-JR motor with an
SF-PR motor
SF-PR slip amount
adjustment mode
P.G060, P.G061 Pr. 673, Pr. 674 5-524
To adjust the motor braking torque DC injection brake
P.G100, P.G101,
P.G110
Pr. 10 to Pr. 12 5-525
To coast the motor to a stop
Output stop function P.G105 Pr. 522 5-528
Selection of motor stop
method
P.G106 Pr. 250 5-287
To use the regeneration unit to
increase the motor braking torque
Regenerative brake selection P.E300, P.T721 Pr. 30, Pr. 599 5-532
To operate the inverter with DC power
supply
DC feeding mode P.E300 Pr. 30 5-532
To avoid overvoltage alarm due to
regenerative driving by automatic
adjustment of the output frequency
Regeneration avoidance
function
P.G120 to P.G125
Pr. 882 to Pr. 886,
Pr. 665
5-540
To decrease the deceleration time of
the motor Increased magnetic
excitation deceleration
P.G130 to P.G132 Pr. 660 to Pr. 662 5-544
To select the control method Control method selection P.G200 Pr. 800 5-38
To secure the low-speed torque by
compensating the slip of the motor
Slip compensation P.G203 to P.G205 Pr. 245 to Pr. 247 5-546
To adjust the speed control gain Speed control gain
P.G211, P.G212
P.G311, P.G312
Pr. 820, Pr. 821,
Pr. 830, Pr. 831
5-52
To adjust the torque control gain Torque control gain
P.G213, P.G214,
P.G313, P.G314 Pr. 824, Pr. 825,
Pr. 834, Pr. 835
5-52
To stabilize torque feedback signal Torque detection filter P.G216, P.G316 Pr.827, Pr.837 5-56
To suppress the machine resonance Speed smoothing control P.G410, P.G411 Pr. 653, Pr. 654 5-546
To adjust the speed gain for Advanced
magnetic flux vector control
Speed control gain P.G932, P.G942 Pr. 89, Pr. 569 5-42