Mitsubishi Electric FR-F800, Инструкция по эксплуатации

Страница: 547 / 834

Parameters (A) Application parameters
FR-F800 5 - 385
Setting multiple PID pre-charge functions
●
When the second pre-charge function is set, two sets of pre-charge functions can be switched for
use. The second pre-charge function is enabled by turning ON the RT signal.
●
The second pre-charge function parameters and signals function in the same way as the following
parameters and signals of the first pre-charge function. Refer to the first pre-charge function when
setting the second pre-charge functions.
Classification
First pre-charge function parameters Second pre-charge function parameters
Pr. Name Pr. Name
Parameter
760 Pre-charge fault selection 765 Second pre-charge fault selection
761 Pre-charge ending level 766 Second pre-charge ending level
762 Pre-charge ending time 767 Second pre-charge ending time
763 Pre-charge upper detection level 768
Second pre-charge upper detection
level
764 Pre-charge time limit 769 Second pre-charge time limit
1132 Pre-charge change increment amount 1133
Second pre-charge change increment
amount
Tab. 5-191: Parameters for setting multiple PID pre-charge functions
Classification
First pre-charge function parameters Second pre-charge function parameters
Signal Name Signal Name
Input signal X77 Pre-charge end command X78 Second pre-charge end command
Output signal
Y49 During pre-charge operation Y50 During second pre-charge operation
Y51 Pre-charge time over Y52 Second pre-charge time over
Y53 Pre-charge level over Y54 Second pre-charge level over
Tab. 5-192: I/O signals for multiple PID pre-charge functions
NOTES The second PID pre-charge function is valid also when the first pre-charge function is set to invalid
and the second pre-charge function is set.
When "10" (second function enabled only during constant-speed operation) is set to Pr. 155, the
second PID function is not selected even if the RT signal turns ON.