Mitsubishi Electric FR-F800, Инструкция по эксплуатации

Страница: 395 / 834

Parameters (M) Monitor display and monitor output signal
FR-F800 5 - 233
●
When using the RY, RUN, and RUN3 signals, refer to the following and assign the functions by Pr.
190 to Pr. 196 (output terminal function selection).
Fault output signals (ALM, ALM2)
●
The Fault (ALM, ALM2) signals are output when the inverter protective function is activated.
●
The ALM2 signal stays ON during the reset period after the fault occurs.
●
To use the ALM2 signal, set "94 (positive logic) or 194 (negative logic)" in any of Pr. 190 to Pr. 196
(output terminal function selection) to assign the function to the output terminal.
●
The ALM signal is assigned to the A1B1C1 contacts in the initial status.
Output signal
Pr. 190 to Pr. 196 settings
Positive logic Negative logic
RY 11 111
RUN 0 100
RUN3 45 145
Tab. 5-103: Assignment of the signals
NOTE The RUN signal (positive logic) is assigned to the terminal RUN in the initial status.
I001153E
Fig. 5-96: Fault signals
NOTE For the inverter fault details, refer to page 6-9.
Inverter alarm occurrence (trip)
Output
fr
eque
nc
y
ALM
Reset ON
Time
RES
ALM2
Reset processing
(about 1s)
ON
ON
ON
OFF
OFF
OFF